A pipe usually fails inside a wall cavity, which means the visible damage is only a fraction of what's actually happening behind the drywall.
We open the wall cavity carefully, only as far as moisture readings say is necessary, rather than tearing out an entire wall.
We'll walk you through shutoff steps over the phone if you call before we arrive.
Our Mission, OR crews trace pressure loss to identify the failure point before opening drywall.
We open wall cavities in a controlled, targeted way based on documented moisture data.
Our Mission, OR team works alongside your plumber or one we can refer, so the repair and drying stay coordinated.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our Mission, OR crews run it.
We locate and confirm the shutoff valve is closed the moment the crew arrives.
Diagnostics narrow down the exact wall section affected.
We extract from within the cavity itself, not just the surface that's visible.
Saturated insulation is removed and replaced, while drywall is cut only at the confirmed wet line.
Drying continues until wall cavity moisture readings hit dry standard.
We coordinate scheduling with a licensed plumber for the pipe repair itself.
We'll walk you through locating the shutoff valve over the phone if needed.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
We diagnose the leak location and provide a written estimate for extraction and drying before removal begins.
The job isn't done until both drying and repair coordination are confirmed.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
Only the compromised section comes out, not the full wall.
We handle the water damage mitigation and coordinate directly with a licensed plumber for the pipe repair itself.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Most burst pipe jobs dry out within about a week, similar to other structural drying timelines.
Mission sits within our core burst pipe response zone.
Speak directly with our burst pipe response team.
Call +1-844-578-1604